Sep 11, 2009 · Yes newbie question here. What other throttle body will mate to GVR4. I am looking to get one locally to remove the isc and plug the coolant line. Would N/T throttle work …

Sep 9, 2012 · B, when stripping and manually extending the ISC while mounted on the Idle control block it closes the orifice but doesn't seal completely. Is this normal? I tested using Carb …

Jul 9, 2003 · I replaced the ISC unit with one I got from Gabor, replaced the throttle body shaft seals (which were basically not there anymore), re-adjusted the Throttle Position Sensor, and …

Mar 11, 2007 · hinking about using a 1G FIAV Blockoff Plate and wanted to know how bad would it be if i did not run a isc motor. I am running a aem ems. The car has no A/C. Still has p/s.

Apr 21, 2013 Newbies Replies 8 Views 3K Apr 23, 2013 tintoy ISC open too much during idle mjdarg Jul 30, 2015 Newbies Replies 6 Views 2K Aug 1, 2015 prove_it 2g biss manitousxti …

Jul 5, 2011 · Finally since the ISC is old it could be faulty. I purchased a new ISC but it seems the JDM and USDM ISCs are different so I am stuck with the old ISC at present. Any of these …

Oct 4, 2009 · That ISC trace is often the first victim of acid leakage from the 47uF cap. 2. Set the idle speed, as per the VFAQ: click 3. Check your base timing with a timing light, as per the …

Aug 13, 2010 · So replaced the ISC after my last ecu blew a driver, I replaced the ecu and rewired the pump as some of you may remember, I have a bad idle surge now, and I adjusted the biss …

Jun 29, 2010 · The isc is rebuilt and the throttle position sensor tested ok when the throttle body was rebuilt. I got a logger the yesterday and set the tps. I'm not sure what the hell could be …

Oct 14, 2009 · I was just looking into the procedure to replacing the ISC or stepper motor, which I plan on doing tomorrow, and in the manual all I can find are testing procedures. Is there …